3L Section [1 Series or 67 PoweRated]

3L Fractional Horsepower belts - 10mm x 6mm

Also known as "1 " Section

Can be replaced with the kevlar 67 Series Powerated belt

Belt Numbers	Outside Length	Top Width

3L150 1150	381 mm [15"]	10 mm
3L160 1160	406 mm [16"]	10 mm
3L170 1170	432 mm [17"]	10 mm
3L180 1180	457 mm [18"]	10 mm
3L190 1190	483 mm [19"]	10 mm
3L200 1200	508 mm [20"]	10 mm
3L210 1210	533 mm [21"]	10 mm
3L220 1220	559 mm [22"]	10 mm
3L230 1230	584 mm [23"]	10 mm
3L240 1240	610 mm [24"]	10 mm
3L245 1245	622 mm [24.5"]	10 mm
3L250 1250	635 mm [25"]	10 mm
3L260 1260	660 mm [26"]	10 mm
3L270 1270	686 mm [27"]	10 mm
3L280 1280	711 mm [28"]	10 mm
3L290 1290	737 mm [29"]	10 mm
3L300 1300	762 mm [30"]	10 mm
3L310 1310	787 mm [31"]	10 mm
3L320 1320	813 mm [32"]	10 mm
3L330 1330	838 mm [33"]	10 mm
3L340 1340	864 mm [34"]	10 mm
3L350 1350	889 mm [35"]	10 mm
3L360 1360	914 mm [36"]	10 mm
3L370 1370	940 mm [37"]	10 mm
3L380 1380	965 mm [38"]	10 mm
3L390 1390	991 mm [39"]	10 mm

Truflex® belts are engineered with superior length stability for minimal take-up requirements, perfect for all industrial, light-duty applications, including fractional horsepower (FHP) motors and applications using backside idlers. Flex-bonded cords are strongly secured to the belt’s body for equal load distribution and absorption of bending stress without cord deterioration. Gates Curves provide proper cord support and full contact with the sheave-groove for uniform loading, uniform wear, and increased belt life. The Flex-Weave® Cover is constructed for longer cover life, providing the belt's core with extended protection from oil, dirt, and heat.

Meets RMA oil and heat-resistant standards and static conductivity requirements.
Note: Truflex belts are offered in cross sections 2L (0), 3L (1 & 67), 4L (2 & 68), 5L (3 & 69).
Runs with smooth, quiet operation.
Minimum pulley diameter for 3L section V-Belts: 38mm.
Minimum flat side idler pulley diameter for 3L setion V-belt: 50mm

Scroll down for further information

↓